LD-18
Advanced “Pinpoint” technology finding water leaks at their exact location.
TECHNICAL SPECIFICATIONS
Additional information
Amplifier Size | 6.4" x 3.0" x 5.7" (16.3 cm x 7.6 cm x 14.5 cm) |
---|---|
Amplifier Weight | 2.2 lbs (including 4 C batteries) (997.9 kg) |
Amplifier Input Power | Four (4) C dry cell batteries |
Amplifier Battery Life | (continuous use) 24 hours minimum |
Amplifier Frequency Range | 50 Hz to 2200 Hz |
Amplifier Amplification | Combined Sensitivity and Amplification: 900 V/G or higher (at 400 Hz) |
Amplifier Sensor | Type: Piezo electric ceramic |
Amplifier Warranty | 4 Years |
ABS Carrying Case Size | 18.5" x 14.6" x 7.5" (470 mm x 371 mm x 190 mm) |
ABS Carrying Case Weight | 15.8 lbs (7.16 kg) |
Key Features
- Easy and simple one-hand operation; built-in handle
- Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
- Volume built into the on/off key; just hold down the key while it cycles through the settings
- The electronic keypad “clicks” when a key is depressed. A “real” speaker is in the front panel, providing outstanding volume.
- Microprocessor remembers the volume and gain settings from the last time the unit was on Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
- Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼” tapered to 2 ½”-wide X 4 ½” tapered to 2 ½”-deep) provide the best structural integrity in a hand-held locator.
- Lightweight; only about two pounds including batteries
- Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
- Soft pack carrying case included (optional hard case available) Battery compartment separated from electronic components and the circuit board. No exposing electronics to replace the batteries.