LD-7
Compact, easy-to-use Water Leak Detector that fits in the palm of your hand.
TECHNICAL SPECIFICATIONS
Additional information
Amplifier Size | 5.7" x 1.25" x 3" (14.5 cm x 3.3 cm x 6.8 cm) |
---|---|
Amplifier Weight | 8.0 lb. (3.6 kg) |
Amplifier Input Power | Two (2) AA dry cell batteries (1.5 V x 2) |
Amplifier Battery Life | 30 Hours |
Amplifier Frequency Range | 100Hz to 1500Hz |
Amplifier Power Consumption | 20 mA Nominal (30-hour life) |
Amplifier Input Impedance | 430k ohm ±/- 1% |
Amplifier Output Impedance | 4-10 ohm |
Amplifier Amplification | 56 dB±/- 3% |
Amplifier Warranty | 4 Years |
ABS Carrying Case Size | 14" x 10.5" x 6" (35.6 cm x 26.7 cm x 15.2 cm) |
ABS Carrying Case Weight | 5.84 lb. (2.65 Kg) |
Key Features
- Easy and simple one-hand operation; built-in handle
- Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
- Volume built into the on/off key; just hold down the key while it cycles through the settings
- The electronic keypad “clicks” when a key is depressed. A “real” speaker is in the front panel, providing outstanding volume.
- Microprocessor remembers the volume and gain settings from the last time the unit was on Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
- Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼” tapered to 2 ½”-wide X 4 ½” tapered to 2 ½”-deep) provide the best structural integrity in a hand-held locator.
- Lightweight; only about two pounds including batteries
- Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
- Soft pack carrying case included (optional hard case available) Battery compartment separated from electronic components and the circuit board. No exposing electronics to replace the batteries.