WIC
The Wireless Inductive Clamp is a self-contained, stand-alone, transmitting inductive coupler.
TECHNICAL SPECIFICATIONS
Additional information
Transmitter Available Operating Frequencies | 33kHz (32,768Hz), 65kHz (65,536Hz) & 82kHz (82,315Hz) |
---|---|
Transmitter Indicators | LED lights |
Transmitter Output Power Levels | Low Power / High Power |
Transmitter Power Source | Rechargeable Li-Ion Battery |
Transmitter Charging | Standard USB supply |
Transmitter Battery Life | 16 Hours (continuous use) |
Transmitter Operating Temperature | -4° F to 140° F (-20° C to 60° C) |
Transmitter Ingress Protection Rating | IP65 |
Transmitter Inside Diameter | 4.2 inches (10.67 cm) |
Transmitter Dimensions | 5.6” x 10.8” x 1.0” (14.2cm x 27.4cm x 2.4cm) |
Transmitter Weight | 0.8 lbs (0.362kg) |
Transmitter Country of Origin | United States of America |
Transmitter Warranty | 1 Year warranty. 48 Month (4 Years) Warranty when registered at http://www.ssilocators.com/warranty-registration within 1 month of the date of purchase. |
Key Features
- Easy and simple one-hand operation; built-in handle
- Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
- Volume built into the on/off key; just hold down the key while it cycles through the settings
- The electronic keypad “clicks” when a key is depressed. A “real” speaker is in the front panel, providing outstanding volume.
- Microprocessor remembers the volume and gain settings from the last time the unit was on Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
- Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼” tapered to 2 ½”-wide X 4 ½” tapered to 2 ½”-deep) provide the best structural integrity in a hand-held locator.
- Lightweight; only about two pounds including batteries
- Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
- Soft pack carrying case included (optional hard case available) Battery compartment separated from electronic components and the circuit board. No exposing electronics to replace the batteries.