PL-G
Pipe & Cable Locator with 4 detecting methods and multi-frequency operation.
TECHNICAL SPECIFICATIONS
Additional information
Transmitter Size | 11.0 in x 9.5 in x 4.1 in (29.9 cm x 24.1 cm x 10.4 cm) |
---|---|
Transmitter Weight | 5.5 lbs (2.5 kg) |
Transmitter Input Power | DC 12 volts (Four (4) "C" size batteries or external 12v battery) |
Transmitter Battery Life | ≈ 20 Hours Typical(Alkaline) |
Transmitter Operating Temperature | 14° to 131° F (-10° to 55° C) |
Transmitter Frequency | 8 kHz, 27 kHz, and 83 Hz |
Transmitter Output Power | 0.5/ 1 watt Inductive mode |
Transmitter Transmitting Mode | Continuous Wave (non-modulating) |
Transmitter Antenna | Single-Coil |
Transmitter Depth Accuracy | Up to 16 Feet |
Transmitter Warranty | 3 Years |
Transmitter Wireless Transfer | Bluetooth Ver. 2.1 Class 2 SPP Profile |
Receiver Size | 5.2 in x 11.0 in x 24.0 in (13.2 cm x 27.9 cm x 61.0 cm) |
Receiver Weight | 4.4 lbs (2.0 kg) |
Receiver Power Supply | DC 9 Volts (six (6) "AA" batteries) |
Receiver Battery Life | ≈ 8 Hours Continuous (Alkaline) |
Receiver Operating Temperature | 14° to 131° F (-10° to 55° C) |
Receiver Frequency Display | 8 kHz, 27 kHz or 83 Hz |
Receiver Operating Modes | "Maximum Method", "Continuous Depth Measurement", "BAR Method", and "Sonde" |
Receiver Sensitivity | 0 to 40 |
Receiver Depth Method | Pull up |
Receiver Depth Range | Pull up: 0 to 16.4 feet (0 to 5 m) |
Receiver Warranty | 3 Years |
Key Features
- Easy and simple one-hand operation; built-in handle
- Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
- Volume built into the on/off key; just hold down the key while it cycles through the settings
- The electronic keypad “clicks” when a key is depressed. A “real” speaker is in the front panel, providing outstanding volume.
- Microprocessor remembers the volume and gain settings from the last time the unit was on Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
- Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼” tapered to 2 ½”-wide X 4 ½” tapered to 2 ½”-deep) provide the best structural integrity in a hand-held locator.
- Lightweight; only about two pounds including batteries
- Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
- Soft pack carrying case included (optional hard case available) Battery compartment separated from electronic components and the circuit board. No exposing electronics to replace the batteries.