ML-1

All-inclusive magnetic locator with simple, one-handed operation.

ML-1

All-inclusive magnetic locator with simple, one-handed operation.

The ML-1 is one of SSI's longest-enduring and popular products for magnetic detection. Whether you're seeking corner markers (iron or steel), well casings, steel drums or septic tank handles, this is the go-to magnetic locator for you. And for good reason.

The ML series offers simple one-handed operation with an easy-to-learn keypad featuring only three buttons - no menus or cumbersome instructions to follow. The audio unit has the volume built into the on/off key; just hold down the key while it cycles through the settings. The ML-1 features strong monotube construction, providing structural integrity you can count on.

Technical Specifications

Overall Length:
38.75 in (98.4 cm)
Weight:
2.0 lbs (0.9 kg) including batteries
Input Power:
Two (2) standard 9-volt alkaline batteries
Battery Life:
40 hours minimum
Warranty:
7 years

Key Features

  • Easy and simple one-hand operation; built-in handle
  • Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
  • Volume built into the on/off key; just hold down the key while it cycles through the settings
  • Electronic keypad that "clicks" when a key is depressed. A "real" speaker is in the front panel, providing outstanding volume.
  • Microprocessor remembers the volume and gain settings from the last time the unit was on Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
  • Strong aluminum motnotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼" tapered to 2 ½"-wide X 4 ½" tapered to 2 ½"-deep) provide the best structural integrity in a hand-held locator.
  • Lightweight; only about two pounds intcluding batteries
  • Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
  • Soft pack carrying case included (optional hard case available) Battery compartment separated from electronic components and circuit board. No exposing electronics to replace the batteries.