LC-5000
Powerful Leak Noise Correlator
Key Features
- Easy and simple one-hand operation; built-in handle
- Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
- Volume built into the on/off key; just hold down the key while it cycles through the settings
- The electronic keypad “clicks” when a key is depressed. A “real” speaker is in the front panel, providing outstanding volume.
- Microprocessor remembers the volume and gain settings from the last time the unit was on Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
- Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼” tapered to 2 ½”-wide X 4 ½” tapered to 2 ½”-deep) provide the best structural integrity in a hand-held locator.
- Lightweight; only about two pounds including batteries
- Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
- Soft pack carrying case included (optional hard case available) Battery compartment separated from electronic components and the circuit board. No exposing electronics to replace the batteries.
TECHNICAL SPECIFICATIONS
Additional information
Main Processor Unit Operating Temperature Range | -10º to 140º |
---|---|
Main Processor Unit External Dimensions | 10.7 inches (W) x 7.0 inches (D) x 3.2 inches (H) |
Main Processor Unit Weight | Approx. 4.8 lb. (with batteries) |
Main Processor Unit Battery | Lithium Ion (rechargeable) |
Main Processor Unit Continuous Operating Time | 8 hours minimum (at 20°C, backlight OFF) |
Main Processor Unit Minimum Operating Voltage | 4.2V |
Main Processor Unit Input | Radio x4 or Cable x2 |
Main Processor Unit Display | 7-inch TFT LCD with touch screen |
Main Processor Unit Operation | Polarity correlation |
Main Processor Unit Td Range | ±50ms, ±100ms, d200ms, ±400ms, ±800ms, ±1600ms, 32000ms or automatic setting |
Main Processor Unit Time Resolution | 25 µs (in ±50ms range), 50 µs (in ±100ms range) |
Main Processor Unit Filter Range | THRU, 80Hz to 5,000Hz (4 low and 4 high) |
Main Processor Unit Notch Filter | OFF, 50Hz, 60Hz |
Main Processor Unit Auto Filter | Automatically selected from FFT operation |
Main Processor Unit Data Memory | 100 correlations |
Main Processor Unit FFT Monitor | 1kHz, 2.5kHz, 5kHz (common to both channels) |
Main Processor Unit Sound Memory | For 16 seconds |
Main Processor Unit External Interface | Antenna, Headphone, Power Switch, Cable, RS-232C |
Red, Blue, Yellow and Green Pre-Amplifiers Temp Range | -13º to 140º F |
Red, Blue, Yellow and Green Pre-Amplifiers Applicable Standard | IP68 (weather tight) |
Red, Blue, Yellow and Green Pre-Amplifiers External Dimensions | 3.14 inches (D) x 7.2 inches (H) |
Red, Blue, Yellow and Green Pre-Amplifiers Weight | Approx. 6.3 lb. (with batteries) |
Red, Blue, Yellow and Green Pre-Amplifiers Battery | Lithium Ion (rechargeable) |
Red, Blue, Yellow and Green Pre-Amplifiers Continuous Operating Time | 10 hours minimum (at 20ºC, backlight OFF) |
Red, Blue, Yellow and Green Pre-Amplifiers Input | Input Frequency Range: Input Sensitivity: Signal to Noise Ratio: |
Red, Blue, Yellow and Green Pre-Amplifiers Radio Communication System | Output Frequency: Modulation: Output Power: Output Impedance: |
Sensors Operation Modes | Correlation / Relay / Logger / Relay+Correlation |
Sensors Sensitivity Settings | 2.0 (1 to 20) Steps Manual & Auto |
Sensors Filter Setting Modes | Common / Through |
Sensors Recording | Audio signal recording (300 seconds, logger mode only) |
Sensors GPS Function | Transmit position coordinates & elevation to the Main Unit |
Sensors Weight | 2.2 lbs. |